Table of Contents
Advertisement
Chapter 7: Cabling AT-XEM2 Line Card Ports
Cabling 1Gbps and 10Gbps Ports on AT-XEM2-12XT Line Cards
168
Here are the guidelines to cabling the 1Gbps/10Gbps twisted pair ports on
AT-XEM2-12XT line cards:
The cable specifications for the ports are listed in Table 1 on
page 24.
The connectors on the cables should fit snugly into the ports, and
the tabs should lock the connectors into place.
The default speed setting for the ports is Auto-Negotiation. This
setting is appropriate for ports connected to network devices that
also support Auto-Negotiation.
The ports must be set to Auto-Negotiation, the default setting, to
operate at 1Gbps.
The ports support full-duplex only.
Do not attach cables to ports of static or LACP port trunks until
after configuring the trunks on the switch. Otherwise, the ports will
form network loops that can adversely affect network performance.
Advertisement
Table of Contents
