Allied Telesis AT-SBx908 Installation Manual page 11

AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Figure 110: Closing the Plastic Cover ................................................................................................................................186
Figure 111: Removing the Grounding Wire ........................................................................................................................187
Figure 112: Reinstalling the Nut and Washer on the Grounding Post ................................................................................188
Figure 113: Lifting the Locking Handle and Removing the Power Supply..........................................................................189
Figure 114: Installing the Blank Power Supply Slot Cover .................................................................................................190
Figure 115: Lowering the Locking Handle on the Power Supply Slot Cover ......................................................................191
Figure 116: Loosening the Screws on the Ethernet Line Card ...........................................................................................195
Figure 117: Disconnecting an Ethernet Line Card from the Chassis..................................................................................196
Figure 118: Sliding an Ethernet Line Card from the Chassis..............................................................................................197
Figure 119: Placing the Ethernet Line Card in its Anti-static Bag .......................................................................................198
Figure 120: Loosening the Screws on the AT-FAN08 Module ...........................................................................................199
Figure 121: Disconnecting the AT-FAN08 Module from the Chassis .................................................................................200
Figure 122: Aligning the AT-FAN08 Module in the Chassis Slot ........................................................................................201
Figure 123: Seating the AT-FAN08 Module on the Connector in the Chassis ...................................................................201
Figure 124: Tightening the Two Captive Screws on the AT-FAN08 Module ......................................................................202
Figure 125: Pin Layout (Front View) of the 1Gbps or 10Gbps Ports on the AT-XEM2-12XT Line Card ............................216
11