At-Sbx908 Gen2 Chassis; Figure 1: Front Panel Of The At-Sbx908 Gen2 Chassis; Figure 2: Rear Panel Of The At-Sbx908 Gen2 Chassis - Allied Telesis AT-SBx908 Installation Manual

Chapter 1: Overview

AT-SBx908 GEN2 Chassis

AC Input
Power Connectors
22
The front panel of the AT-SBx908 GEN2 Chassis is shown in Figure 1.
Management Panel
Eight Slots for Ethernet Line Cards
Figure 1. Front Panel of the AT-SBx908 GEN2 Chassis
Note
The switch comes with slot covers on line card slots 2 to 8. Do not
remove the slot covers until after the unit is installed in the
equipment rack. You might bend the chassis and cause
misalignment of the slots and card guides if you lift the chassis into
the equipment rack without the line card slot covers.
The rear panel is shown in Figure 2.
Ground Wire Lug
Figure 2. Rear Panel of the AT-SBx908 GEN2 Chassis
Power Supply Slot (PSU A)
Power Supply Slot (PSU B)
with Blank Cover
AT-FAN08 Fan Units