Verifying A Member Switch; Table 17: Configuring The Member Switch - Part Ii; Table 18: Verifying The Configuration Of A Member Switch - Allied Telesis AT-SBx908 Installation Manual

Table 17. Configuring the Member Switch - Part II (Continued)
Step
10 Return to the Privileged Exec mode.
awplus(config)# exit
11 Save your changes with the WRITE command.
awplus# write
Building configuration ...
[OK]
12 Restart the switch.
awplus# reboot
reboot system? (y/n):
13 Type "Y" for yes.
14 Wait two minutes for the switch to initialize its management software.
15 Go to "Verifying a Member Switch" on page 161.
Verifying a
Member Switch
Table 18. Verifying the Configuration of a Member Switch
Step
1 Start a local management session. Refer to "Starting a Local Management Session" on
page 147.
2 Move to the Privileged Exec mode.
awplus> enable
Description and Command
Perform the steps in Table 18 to confirm the configuration of a member
switch.
Description and Command
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
161