Table of Contents
Advertisement
Chapter 5: Wiring the AT-SBxPWRSYS1-80 DC Power Supply
Connecting the DC Power Wires with the Straight Terminals
122
To use the straight terminals to connect the DC power wires to the positive
and negative terminals on the power supply, perform the following
procedure:
1. Prepare adequate lengths of two stranded 8 AWG power wires by
stripping them as shown in Figure 72 on page 122.
Warning
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation. E10
Figure 72. Stripping the Power Wires
Note
You must use stranded wires with the terminal lugs. You may not
use solid wires.
2. Insert the power wires into the terminals included with the power
supply and use a crimping tool to secure the wires to the terminals.
See Figure 73.
Figure 73. Attaching the Power Wires to the Straight Terminal Lugs
Advertisement
Table of Contents
