Table of Contents
Advertisement
Chapter 5: Wiring the AT-SBxPWRSYS1-80 DC Power Supply
Figure 83. Connecting the Positive (+) Power Wire with a Right Angle
Terminal
7. With a #3 Phillips-head screwdriver, connect the negative (-) power
lead wire to the negative terminal on the power supply, with the
remaining terminal screw removed in step 5. The negative terminal is
on the right. Refer to Figure 84 on page 133.
Allied Telesis recommends tightening the screw to 30 to 40 inch-lbs.
132
Advertisement
Table of Contents
