Figure 46: Lifting The Locking Handle On The At-Sbxpwrsys1-80 Dc Power Supply; Figure 47: Inserting The At-Sbxpwrsys1-80 Dc Power Supply - Allied Telesis AT-SBx908 Installation Manual

Figure 46. Lifting the Locking Handle on the AT-SBxPWRSYS1-80 DC
6. Carefully align the power supply in the slot and slide it into the slot until
it makes contact with the connector inside the chassis. Refer to
Figure 47.
Figure 47. Inserting the AT-SBxPWRSYS1-80 DC Power Supply
7. Gently press on the faceplate of the power supply to seat the unit on
the connector on the backplane of the chassis, and lower the locking
handle to secure the unit in the chassis. Refer to Figure 48 on page 98.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Power Supply
97