Table of Contents
Advertisement
Chapter 6: Configuring Switches for Stacking
Introduction
140
This chapter contains instructions on how to configure switches for
stacking with VCStack. Please review the following information before
performing the instructions:
The procedures should be performed in the order presented here.
The procedures should be performed on each switch, individually.
The procedures include designating the trunk ports for the
switches. If you have not already chosen the trunk ports, select
them before continuing. For background information, refer to
"Stacking Guidelines" on page 43.
If you have already connected network cables to the trunk ports on
the AT-XEM2 Line Cards, remove them before continuing. Trunk
ports should not be cabled yet.
Note
Cabling trunk ports before activating the VCStack feature may result
in loops in your network topology, which can cause poor network
performance.
Advertisement
Table of Contents
