Flow Control - CipherLab 2564 User Manual

2564 Barcode Scanner

2.5.6 FLOW CONTROL

By default, there is no flow control in use. Select the flow control (handshake) method.
Options
No
Scanner Ready
Data Ready
Inverted Data Ready
80
User Guide
Description
No flow control
The scanner will activate the RTS signal upon powering on. After each good
read, the scanner will then wait for the CTS signal to become active. Data
will not be sent until the CTS signal becomes active.
The RTS signal will be activated after each good read. The scanner will
then wait for the CTS signal to become active. Data will not be sent until
the CTS signal becomes active.
It works the same as the Data Ready flow control except that the RTS
signal level is inverted.
*None
Scanner Ready
Data Ready
Invert Data Ready
Enter Setup