Table of Contents
Advertisement
Appendix II
Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здес
For example, '#@GLED,09' is to have the scanner blink for 9 times.
"0x23" + "0x40" + "0x47" + "0x4c" + "0x45" + "0x44" + "0x2c" + "0x30"
+ "0x39" + "0x0d"
EXAMPLE
You may run HyperTerminal.exe on the host computer to send serial commands to the
barcode scanner via RS-232, USB Virtual COM or BT SPP.
For the scanner to stop immediately –
D
For the scanner to resume working –
E
For the scanner to change the beeper to medium volume and beep –
#@101011<CR>
#@////<CR>
For the scanner to change the beeper to minimal volume and beep –
#@101010<CR>
#@////<CR>
For the scanner to change the beeper frequency to 8 kHz (for Good Read Beep only)
and beep –
#@101001<CR>
#@////<CR>
For the scanner to change the beeper length to longest (for Good Read Beep only)
and beep –
#@101008<CR>
#@////<CR>
For the scanner to save the settings, send the serial command "#@109999" –
#@101011<CR>
#@109999<CR>
For the scanner to read the serial number and beep –
#@RDSN<CR>
#@////<CR>
For the scanner to beep for nine times –
#@BEEP,09<CR>
For the scanner's LED indicator to blink in red for nine times –
#@RLED,09<CR>
For the scanner's LED indicator to blink in green for nine times –
#@GLED,09<CR>
Update
241
- Quick Links:
- Enter Configuration Mode
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2564 and is the answer not in the manual?
Questions and answers
how do i set it back to default - 2564
To reset the CipherLab 2564 barcode scanner to factory default settings, scan the "Restore System Defaults" barcode. This will clear the current connection record and reset all settings. The scanner will then restart automatically.
This answer is automatically generated