Power Economy - CipherLab 2564 User Manual

2564 Barcode Scanner

1.1.2 POWER ECONOMY

The scanner features "Power-Saving" and "Auto Power Off" giving consideration to the
power issue that is generally critical for Bluetooth-enabled devices. By the scanner's
support of power economy, its power consumption may progress by the following
transition:
1) running at full CPU speed at power-on
2) shifting to low CPU speed (Power-Saving)
3) finally shutting down automatically (Auto Power Off)
In the following content of this section, you will be guided through the configurations for
the scanner's power economy.
1.1.2.1 POWER-SAVING
For the scanner to save power, you need to appoint the timing for the scanner to shift to
power-saving mode. Make the configuration that best suits your application while noting
the following points:
 Power-Saving: 1~254 minutes configurable. 0= Disable.
By default, the scanner stands by at full-speed for 2 minutes after power-on and
before entering low-speed mode. If Power-Saving isn't desired, set it to 0 to disable it.
Read the setup barcode in the following to achieve the setup.
Note: Power-Saving setting won't take effect when the WPAN connection is established
successfully whether via BT HID or SPP.
1) Read the barcode above to enable the scanner to enter low-speed "Power-Saving".
2) Assign the time for the scanner to enter low-speed mode by reading the
Value" barcode on page 251. For example, read "5" for the scanner to enter
low-speed mode after idleness of 5 minutes.
3) Read the "Validate" barcode on the same page to complete this setting.
22
User Guide
Power-Saving after
0~254 min. (*2)
Enter Setup
"Decimal