Chapter 2
Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь
2.2 BT SPP SLAVE
For BT SPP Slave, refer to
connection settings.
2.2.1 ACTIVATE BT SPP SLAVE MODE
Scan this barcode to have the scanner get into SPP Slave Mode.
2.2.2 INTER-FUNCTION DELAY
By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of millisecond, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the
"Decimal
(millisecond).
3) Read the "Validate" barcode on the same page to complete this setting.
2.2.3 ACK/NAK TIMEOUT
By default, the scanner sends data to the host without waiting for an ACK/NAK response
before sending more data. Specify a value, ranging from 1 to 99 in units of 0.1 second. If
no response within the specified period of time, the scanner will attempt to send the
same data two more times. If all three attempts fail without any notification, data loss
will occur.
1) Read the barcode above to specify the time interval for the scanner to send data and
wait for a response from the host.
Chapter 3 Setting up a WPAN Connection
Value" barcode on page 251 for the desired inter-function delay
Activate BT SPP,
Slave Mode
Inter-Function
Delay... (*0~254)
ACK/NAK Time-out
after ... (*0~99)
Update
for related
61