Host Serial Commands; Serial Commands - CipherLab 2564 User Manual

HOST SERIAL COMMANDS

SERIAL COMMANDS

D
Purpose To disable the scanner.
Remarks "D"
E
Purpose To enable the scanner.
Remarks "E"
#@ nnnnnn <CR>
Purpose To configure the scanner.
Remarks nnnnnn – the six digits of command parameters.
For example, "109952" is to list the current Code ID settings.
"0x23" + "0x40" + "0x31" + "0x30" + "0x39" + "0x39" + "0x35" + "0x32" + "0x0d"
Note: After configuring the scanner, send the serial command "#@109999" to save the
settings.
#@ - - - -<CR>
Purpose To halt the scanner.
Remarks "0x23" + "0x40" + "0x2d" + "0x2d" + "0x2d" + "0x2d" + "0x0d"
#@ . . . . <CR>
Purpose To resume operation.
Remarks "0x23" + "0x40" + "0x2e" + "0x2e" + "0x2e" + "0x2e" + "0x0d"
#@////<CR>
Purpose To respond with a beep.
Remarks "0x23" + "0x40" + "0x2f" + "0x2f" + "0x2f" + "0x2f" + "0x0d"
List Page 3
Update
Appendix II
Serial Command
239