CipherLab 2564 User Manual page 198

2564 Barcode Scanner
After applying AIM Code ID, three characters are added in front of the output data. "]" is
always the first character. The second (Character) and third (Modifier Character) may
vary depending on symbologies. Please refer to the table below.
Symbology Character
Codabar F
Code 11 H
Code 39 A
Code 93 G
Code 128 C
GS1 DataBar e
Family
Interleaved I
25
MSI M
Matrix 25 X
184
User Guide
Modifier Character
0: Standard Codabar symbol. No special processing.
0: Single modulo 11 check character validated and transmitted
1: Two modulo 11 check characters validated and transmitted
3: Check characters validated but not transmitted
?: No check character validation
0: No check character validation nor full ASCII processing. All data
transmitted as decoded.
1: Modulo 43 check character validated and transmitted
3: Modulo 43 check character validated but not transmitted
4: Full ASCII character conversion performed. No check character
validation.
5: Full ASCII character conversion performed. Modulo 43 check
character validated and transmitted.
7: Full ASCII character conversion performed. Modulo 43 check
character validated but not transmitted.
No options specified. Always transmit 0.
0: Standard data packet. No FNC1 in first or second symbol character
position after start character.
1: EAN/UCC-128 data packet. FNC1 in first symbol character position
after start character.
2: FNC1 in second symbol character position after start character.
4: Concatenation according
Transfusion specifications has been performed. Concatenated data
follows.
No option specified at this time. Always transmit 0. GS1 DataBar and
GS1 DataBar Limited transmit with an Application Identifier "01".
0: No check character validation
1: Modulo 10 symbol check character validated and transmitted
3: Modulo 10 symbol check character validated but not transmitted
0: Modulo 10 symbol check character validated and transmitted
1: Modulo 10 symbol check character validated but not transmitted
No options specified. Always transmit 0.
*Disable AIM Code ID
to International
Enter Setup
Society for Blood