Table of Contents
Advertisement
Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь отображат
ENTER CONFIGURATION MODE
For the scanner to enter the configuration mode, have it read the "Enter Setup" barcode
located at the bottom of almost every even page of this manual.
The scanner will respond with six beeps and its LED indicator will become flashing red
after reading the barcode.
For configuring scanner parameters, see "Read a Setup Barcode" below.
EXIT CONFIGURATION MODE
For the scanner to save settings and exit the configuration mode, have it read the
"Update" barcode located at the bottom of almost every odd page of this manual. To exit
the configuration mode without saving any changes, have the scanner read the "Abort"
barcode instead.
Just like reading the "Enter Setup" barcode, the scanner will respond with six beeps
and its LED indicator will become flashing red after reading the barcode. Wait for a
few seconds for the scanner to restart itself.
Enter Setup
Update
Update
Abort
11
- Quick Links:
- Enter Configuration Mode
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2564 and is the answer not in the manual?
Questions and answers
how do i set it back to default - 2564
To reset the CipherLab 2564 barcode scanner to factory default settings, scan the "Restore System Defaults" barcode. This will clear the current connection record and reset all settings. The scanner will then restart automatically.
This answer is automatically generated