Inter-Function Delay - CipherLab 2564 User Manual

Chapter 2 Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь
#@CipherLab
88686471166254
0X
00d0176f0030
The concatenation of setup barcodes can be combined to create a single 2D barcode as below:
2D One-Scan Setup Barcode for connecting with a target device
Exit SPP Master Mode
To stop such re-connection, read "Reset Connection" or "Restore System Defaults" barcode so that
the current connection record (= MAC ID) will be cleared. Then, the scanner will restart itself
automatically. Go through the process in
connection.

2.3.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of millisecond, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the "Decimal
(millisecond).
3) Read the "Validate" barcode on the same page to complete this setting.
Enter Setup
Set connection
Prefix to the target MAC ID
MAC address ID of the target device
3.2.3 Connect to Dongle
Reset Connection
Value" barcode on page 251 for the desired inter-function delay
to establish a new WPAN
Inter-Function
Delay... (*0~254)
Update
65