Table of Contents
Advertisement
Appendix II
Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здес
BT CRADLE SETUP BARCODES & SERIAL COMMANDS
Normally, you can configure the cradle stand by having a connected scanner read
cradle-related setup barcodes.
1) Connect the interface cable, RS-232, Keyboard Wedge or USB, between the cradle
and your computer.
2) For USB Virtual COM, you may need to install its driver first!
3) Connect the power supply cord from the cradle to a proper power outlet.
Read the "Set Connection" label first, and then the "Serial Number" label. Both labels
can be located at the back of the cradle.
4) Refer to 3.1.1 Connect to Cradle for the target scanner to connect to the cradle.
5) Read the following barcodes in sequence to configure the cradle.
For cradle-related setup barcodes, refer to the Serial Command table below. Note that for
the "Version" and "GetID" barcodes, you must run HyperTerminal.exe or any text editor
to receive the information.
If the output interface is RS-232 or USB Virtual COM, run HyperTerminal.exe on
your computer to receive the information.
If the output interface is Keyboard Wedge or USB HID, run any text editor to
receive the information.
Enter Setup
(cradle-related setup barcodes)
Update
Update
243
- Quick Links:
- Enter Configuration Mode
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2564 and is the answer not in the manual?
Questions and answers
how do i set it back to default - 2564
To reset the CipherLab 2564 barcode scanner to factory default settings, scan the "Restore System Defaults" barcode. This will clear the current connection record and reset all settings. The scanner will then restart automatically.
This answer is automatically generated