Cable Auto-Detection Via Bt Cradle; Picklist Mode - CipherLab 2564 User Manual

2564 Barcode Scanner

1.12 CABLE AUTO-DETECTION VIA BT CRADLE

By default, this function is enabled that the cradle will detect the interface automatically.
Connect the BT cradle to a host computer using the provided interface cable. After the BT
connection between the scanner and the cradle is established, users can have the
scanner read the setting barcodes below to enable/disable cable auto-detection on the
cradle.
Cable Auto-Detect
Keyboard Wedge
RS-232
USB
Note: If "USB Virtual COM" is desired, have the scanner read the setup barcodes.

1.13 PICKLIST MODE

Picklist mode enables the decoder to decode only the barcodes aligned at the center
under the laser aiming pattern.
44
User Guide
Defaults
PCAT (US) for keyboard type
115200 bps, 8 bits, No parity, 1 stop bit
USB HID and PCAT (US) for keyboard type
*Enable
Disable
Enable
*Disable
Enter Setup