Activate The Concatenation Of Barcodes - CipherLab 2564 User Manual

2564 Barcode Scanner
Note: If not reading 0000 for any length, the 4-digit length must exclude prefix, suffix
(0x0d by default), length code, etc.
4) Matching Character setting – read the
st
the 1 character that must be found matching in the (first) barcode. For example,
read "4" and "1" for matching character "A" as the first character in the barcode or
read "00" for any character.
5) Read twice the "F" barcode on page 252 ("FF") to complete the setting of each
barcode.
6) Read the "Validate" barcode to end the editing of the barcode set.

5.6.2 ACTIVATE THE CONCATENATION OF BARCODES

By default, the output sequence editing of the concatenation of barcodes is not applied.
When "Enforce Output Sequence" is enabled, all barcodes read by the scanner must meet
with the criteria for the concatenation. If data is found excluded from all output sequence
sets (= not meeting with the criteria), the scanner will not accept the reading, and
therefore, data will not be transmitted.
When "Apply Output Sequence" is enabled, only barcodes found meeting with the criteria
are counted for the concatenation. Those found not meeting with the criteria are
processed normally and individually.
Note: When it requires reading more barcodes to complete the "output sequence"
requirements, the scanner will respond with one short beep (low tone). After
reading an acceptable barcode, its LED indicator will become solid green and go off
quickly (= Good Read).
Upon completion of reading acceptable barcodes, the scanner will respond with
one short beep (high tone) and its LED indicator will become solid green and go off
quickly (= Good Read).
198
User Guide
"Hexadecimal Value" barcode on page 252 for
Enter Setup