Understanding The Barcode Scanner; Battery; Turn On-Off The Scanner - CipherLab 2564 User Manual

Chapter 1

UNDERSTANDING THE BARCODE SCANNER

This chapter explains the features and usage of the barcode scanner.
IN THIS CHAPTER
1.1 Battery ...................................................................... 21
1.2 Memory ..................................................................... 26
1.3 LED Indicator ............................................................. 29
1.4 Beeper....................................................................... 31
1.5 Send "NR" to Host ....................................................... 35
1.6 Scan Modes ................................................................ 36
1.7 Scanning Timeout ....................................................... 40
1.8 Delay between Re-read ................................................ 41
1.9 Read Redundancy (1D) ................................................ 42
1.10 Addon Security for UPC/EAN Barcodes ......................... 43
1.11 Auto-Sense Mode ...................................................... 43
1.13 Picklist Mode ............................................................. 44
1.14 Mobile Phone/Display Mode ........................................ 45
1.15 Serial Number Stamp ................................................ 45
1.16 2D Decode Settings ................................................... 46

1.1 BATTERY

The scanner is powered by a rechargeable 3.7 V/800 mAh Li-ion battery, and it takes
approximately 5 hours to charge the battery to full (from the power adaptor). However,
the charging time may vary by working condition. For intensive data collection, you may
need a spare battery for uninterrupted operation.
Note: The scanner supports power economy. Refer to settings of "Power Economy", "Sniff
Mode", as well as "Low Battery Alarm".

1.1.1 TURN ON-OFF THE SCANNER

Turn on the scanner...
After installing the battery, pull down the trigger for about 2 seconds. The scanner will respond
with a long beep (high tone), then the LED will become solid red and go off quickly.
Turn off the scanner...
Remove the battery directly or let it turn off automatically in specific circumstances.
21
Update