Scanning Timeout - CipherLab 2564 User Manual

2564 Barcode Scanner

1.7 SCANNING TIMEOUT

Specify the scanning time interval (1~254 sec.; 0= Disable) when the scan mode is set
to any of the following –
Laser mode

Auto Off mode

Auto Power Off mode

 Aiming mode
1) Read the barcode above to specify the time interval before the scan engine times out.
2) Read the "Decimal
scanner to automatically shut down after being idle for 15 seconds.
3) Read the "Validate" barcode on the same page to complete this setting.
40
User Guide
Value" barcode on page 251. For example, read "1" and "5" for the
Scanner Time-out
after 0~254 sec.
(*10)
Enter Setup