Charging The Battery Via Cradle - CipherLab 2564 User Manual

2564 Barcode Scanner

CHARGING THE BATTERY VIA CRADLE

The battery may not be charged to full for shipment. When you first receive the package,
you will need to charge the battery to full before using the scanner. When using the
RS-232 cable, it takes approximately 5 hours to charge the battery to full (from the
power adaptor).
Note: Battery charging stops when the temperature drops below 0°C or exceeds 40°C. It
is recommended to charge the battery at room temperature (18°C to 25°C) for
optimal performance.
1) Install the battery to the scanner.
2) Seat the scanner in the cradle.
3) Connect the cradle to your computer or notebook via the USB or RS-232 cable.
4) Connect the power supply cord from the cradle to a proper power outlet.
Warning: RS-232/USB interface both require connecting the power supply cord.
When the stand is solely on USB power, the current may be insufficient for
it to function normally. You must connect the power supply cord.
5) The scanner LED will be flashing red during charging.
When the charging is done, the LED will turn off.

When charging error occurs, the LED will turn solid red.

6) The LED for communications on the cradle will first become solid blue while initializing.
Refer to the table above for details on different stage of communications.
4
User Guide
Enter Setup