Electrical Installation, Control Terminals - Danfoss VLT AutomationDrive FC 302 Instruction Manual

Installation
3.4.19 Electrical Installation, Control
Terminals
To connect the cable to the terminal:
1. Strip insulation by about 0.35–0.4 in [9–10 mm]
Electrical installationControl terminals
Figure 3.22 Length to Strip the Insulation
2. Insert a screwdriver (max. 0.016x0.1 in [0.4x2.5
mm]) in the square hole.
3. Insert the cable in the adjacent circular hole.
Figure 3.23 Inserting the Cable in the Terminal Block
4. Remove the screwdriver. The cable is now
mounted in the terminal.
MG37A222
Instruction Manual
To remove the cable from the terminal:
1.
2.
9 - 10 mm
(0.37 in)
Figure 3.24 Removing the Screwdriver after Cable Insertion
Figure 3.25 Control Terminal Locations
Danfoss A/S © Rev. 2014-02-07 All rights reserved.
Insert a screwdriver (max. 0.016x0.1 in [0.4x2.5
mm]) in the square hole.
Pull out the cable.
3 3
33