Danfoss VLT AutomationDrive FC 302 Instruction Manual page 130

Status Messages
Sleep Mode
Speed high
Speed low
Standby
Start delay
Start fwd/rev
8 8
Stop
Trip
Trip lock
Table 8.3 Operation Status
NOTICE!
In auto/remote mode, the adjustable frequency drive
requires external commands to execute functions.
128
Instruction Manual
The energy saving function is enabled. The
motor has stopped but restarts automatically
when required.
Motor speed is above the value set in
4-53 Warning Speed High.
Motor speed is below the value set in
4-52 Warning Speed Low.
In Auto On mode, the adjustable frequency
drive starts the motor with a start signal from
a digital input or serial communication.
In 1-71 Start Delay, a delay starting time was
set. A start command is activated and the
motor will start after the start delay time
expires.
Start forward and start reverse were selected
as functions for two different digital inputs
(parameter group 5-1* Digital Inputs). The
motor starts in forward or reverse depending
on which corresponding terminal is activated.
The adjustable frequency drive has received a
stop command from the LCP, digital input, or
serial communication.
An alarm occurred and the motor is stopped.
Once the cause of the alarm is cleared, the
adjustable frequency drive can be reset
manually by pressing [Reset] or remotely by
control terminals or serial communication.
An alarm occurred and the motor is stopped.
Once the cause of the alarm is cleared, power
must be cycled to the adjustable frequency
drive. The adjustable frequency drive can then
be reset manually by pressing [Reset] or
remotely by control terminals or serial
communication.
Danfoss A/S © Rev. 2014-02-07 All rights reserved. MG37A222