Danfoss VLT AutomationDrive FC 302 Instruction Manual page 64

Programming
2-20 Release Brake Current
Range:
Size
related 16-37 A]
*
6 6
2-21 Activate Brake Speed [RPM]
Range:
Size
related
*
2-22 Activate Brake Speed [Hz]
Range:
Size related
*
2-23 Activate Brake Delay
Range:
0 s [0 - 5 s] Enter the brake delay time of the coast after
*
62
Function:
[ 0 - par. Set the motor current for release of the
mechanical brake, when a start condition
is present. The default value is the
maximum current the inverter can provide
for the particular power size. The upper
limit is specified in 16-37 Inv. Max. Current.
NOTICE!
When Mechanical brake control
output is selected but no
mechanical brake is connected, the
function will not work by default
setting due to too low motor
current.
Function:
[0 - 30000 Set the motor speed for activation of
RPM] the mechanical brake when a stop
condition is present. The upper
speed limit is specified in
4-53 Warning Speed High.
Function:
[ 0 - 5000.0 Set the motor frequency for
Hz] activation of the mechanical
brake when a stop condition is
present.
Function:
ramp-down time. The shaft is held at zero speed
with full holding torque. Ensure that the
mechanical brake has locked the load before the
motor enters coast mode.
Danfoss A/S © Rev. 2014-02-07 All rights reserved.
Instruction Manual
2-24 Stop Delay
Range:
0 s [0 - 5 s] Set the time interval from the moment when the
*
2-25 Brake Release Time
Range:
0.20 s
*
2-26 Torque Ref
Range:
0 %
*
2-27 Torque Ramp Up Time
Range:
0.2 s
*
2-28 Gain Boost Factor
Range:
1 [0 - 4 ] Only active in flux closed-loop. The function
*
Function:
motor is stopped until the brake closes. This
parameter is a part of the stopping function.
Function:
[0 - 5 s] This value defines the time it takes for the
mechanical brake to open. This parameter
must act as a timeout when brake feedback is
activated.
[ 0 - 0 %]
Function:
[0 - 5 s] The value defines the duration of the torque
ramp in clockwise direction.
Function:
ensures a smooth transition from torque control
mode to speed control mode when the motor
takes over the load from the brake.
Function:
MG37A222