Network Status - Aruba AP-303H Series Installation Manual

Table 2 Radio Status LEDs
Color/State
Off
Green/solid
Green/blinking
Amber/solid
Amber/flashing
Alternating

Network Status

The Network Status LED, located on the sides of the E1-E3 ports, indicates activity transmitted to/from the wired
ports, as shown in
Table 3 Network Status LEDs
Color/State
Off
Green/solid
Green/blinking
Amber/solid
Amber/blinking
PoE-PSE Status
The PoE-PSE LED are located above ports E1-E3, and indicate when the access point is operating as Power
Sourcing Equipment (PSE), providing Power over Ethernet (PoE) to an external device that is physically connected
to the E3 port by Ethernet cable, as shown in
Table 4 PoE-PSE Status LEDs
Color/State
Off
Green/solid
Green/blinking
LED Display Settings
The LEDs have three operating modes that can be selected in the system
management software:
Default mode: Refer to

Off mode: LEDs are off

Aruba 303H Series Hospitality Access Point
Meaning
Meets one of the following conditions:
both radios are disabled

device is powered off

Both radios enabled in access mode
One radio enabled in access mode; one radio
1
disabled
Both radios enabled in monitor mode
Device ready; operating in power-save mode, with uplink negotiated at
suboptimal speed (<1Gbps)
3
Error condition
Table 3.
Meaning
Meets one of the following conditions:
device is powered off

port is disabled

no link/activity

Link established at max speed (1Gbps)
Activity detected across a max speed link
Link established at reduced speed (10/100Mbps)
Activity detected across a reduced speed link
Meaning
Access point not supplying PoE, or powered off
Access point supplying power to a connected device
Negotiating PoE power supplied to a connected device
Tables 1-3
| Installation Guide
Table 4.
3