Verifying Post-Installation Connectivity; Electrical And Environmental Specifications; Regulatory Model Name - Aruba 510 Series Installation Manual

Software
For instructions on choosing operating modes and initial software configuration, refer to the AP Software Quick
Start Guide.
Aruba access points are classified as radio transmission devices, and are subject to government regulations of
the host country. The network administrator(s) is/are responsible for ensuring that configuration and operation
of this equipment is in compliance with their country's regulations. For a complete list of approved channels in
!
your country, refer to the Aruba Downloadable Regulatory Table at
Japan – Please disable the 11ax (High Efficiency) operation until such time it is confirmed that has Japan
approved a regulatory framework for 11ax.

Verifying Post-Installation Connectivity

The integrated LED on the access point can be used to verify that the access point access point is receiving power
and initializing successfully (see
on verifying post-installation network connectivity.

Electrical and Environmental Specifications

For additional specifications on this product, please refer to the product data sheet at
Electrical
Ethernet:

E0 port: 100/1000/2500BaseT auto-sensing MDI/MDX wired RJ45 network connectivity port

E1 port: 100/1000BaseT auto-sensing MDI/MDX wired RJ45 network connectivity port

Power:

12V DC power interface, support powering through AC-to-DC power adapter (AP-AC-12V30B)

Power over Ethernet (PoE): 802.3af, 802.3at or 802.3bt compliant source

If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL listed,
with an output rated 12V DC, minimum 0.75A, marked "LPS" and "Class 2," and suitable for plugging into a
standard power receptacle in the US and Canada.
Environmental
Operating:

Temperature: 0°C to +50°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport:

Temperature: -40°C to +70°C (-40°F to +158°F)

Humidity: 5% to 93% non-condensing

!
The Aruba 510 Series access points are for indoor use only. The access point, AC adapter, and all connected
cables are not designed for outdoor use.
!
This device is intended for stationary use in partly temperature controlled weather-protected environments.

Regulatory Model Name

The following regulatory model numbers (RMN) apply to the 510 Series:
AP-514 RMN: APIN0514

Aruba 510 Series Campus Access Points
Table 1 Table 2). Refer to the AP Software Quick Start Guide for further details
-
| Installation Guide
support.arubanetworks.com
www.arubanetworks.com
.
9