Regulatory Model Name; Safety And Regulatory Compliance; Federal Communication Commission - Aruba 630 Series Installation Manual

Temperature: 0°C to +50°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport:

Temperature: -40°C to +70°C (-40°F to +158°F)

Humidity: 5% to 93% non-condensing

!
The Aruba 630 Series access points are for indoor use only. The access point, AC adapter, and all connected
cables are not designed for outdoor use.
!
This device is intended for stationary use in partly temperature controlled weather-protected environments.

Regulatory Model Name

The following regulatory model numbers (RMN) apply to the 630 Series:
AP-635 RMN: APIN0635


Safety and Regulatory Compliance

RF Radiation Exposure Statement: This equipment complies with RF radiation exposure limits. This
!
equipment should be installed and operated with a minimum distance of 13.78 inches (35cm) between the
radiator and your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclaration de la concernant l'exposition aux rayonnements à fréquence radioélectrique (FR) : Cet
!
appareil est conforme aux limites d'exposition aux rayonnements FR établies. Il doit être installé et utilisé à une
distance minimale de 35 cm (13,78 pouces) entre le radiateur et votre corps. Cet émetteur ne doit pas être
installé ou utilisé à proximité immédiate d'une autre antenne ni d'un autre transmetteur.
!
Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
!
Toute modification effectuée sur cet équipement sans l'autorisation expresse de la partie responsable de la
conformité est susceptible d'annuler son droit d'utilisation.

Federal Communication Commission

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the manufacturer's instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Aruba 630 Series Campus Access Points
| Installation Guide
7