Electrical And Environmental Specifications; Regulatory Model Name; Safety And Regulatory Compliance - Aruba 318 Series Installation Manual

Electrical and Environmental Specifications

Electrical
Ethernet

One 10/100/1000Base-T auto-sensing Ethernet RJ-45 Interfaces

Power over Ethernet (IEEE 802.3at compliant)

Environmental
Operating

Temperature: -40ºC to 55ºC (-40ºF to 131ºF)

Storage

Temperature: -40ºC to 70ºC (-40ºF to 158ºF)

Humidity: 5% to 93% non-condensing

For additional specifications on this product, please refer to the data sheet. The data sheet can be found at
www.arubanetworks.com.
BLE Radio Default State
When the Access Point is in factory default state the integrated BLE radio is enabled. This applies to the non-TAA/
FIPS product SKUs only. On the TAA/FIPS products, the BLE radio is disabled when the unit is in factory default
conditions. Once the AP has established a connection with its management platform, the BLE radio state is
updated to match what's configured there. This state is maintained if the AP is power-cycled or rebooted.
Console Port Default State
When the Access Point is in factory default state the console interface (both physical port and BLE) is enabled
with default credentials (username is "admin" and password is the serial number of the unit). Once the AP has
established a connection with its management platform, the console port state (enabled/disabled) and access
credentials are updated to match what's configured there. State and credentials are maintained if the AP is
power-cycled or rebooted.

Regulatory Model Name

The following regulatory model names apply to the 318 Series:
AP-318: APIN0318


Safety and Regulatory Compliance

FCC
To view the FCC ID for controller-managed access points:
1. Log into the controller WebUI
2. Navigate to Maintenance > Controller > About
To view the FCC ID for Instant access points:
1. Log into the virtual controller WebUI
2.
Navigate to Maintenance > About
RF Radiation Exposure Statement: This equipment complies with RF radiation exposure limits. This equip-
!
ment should be installed and operated with a minimum distance of 13.78 inches (35 cm) between the radiator
and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating in con-
junction with any other antenna or transmitter.
10 Aruba 318 Series Wireless Access Point
| Installation Guide