Download Print this page

Removing The Dc Controller Pcb - Canon MF8580Cdw Service Manual

Mf8500/mf8200 series
Hide thumbs
Also See for MF8580Cdw 
Manual - 750 pages
User manual - 750 pages
Getting started - 292 pages

Advertisement

4
Disassembly/Assembly > Controller System > Removing the DC Controller PCB > Procedure
MEMO
MAC address information is changed after replacement of the Main Controller PCB.
Therefore, when the PC and the machine are connected by the network, the PC will
not be able to recognize the machine on the network. When the PC and the machine
are connected by the USB memory device, the PC will not be able to recognize the
machine if the USB ID is changed. It becomes therefore necessary to reinstall the
driver.
In the case of a model without fax for EUR (MF8540/MF8230), perform the following works.
MEMO
After replacing the Main Controller PCB, the value of the service mode (SDTM-DSP)
to set whether to display or hide the automatic shutdown menu becomes "0" (default
value).
In that case, the automatic shutdown menu is not displayed on the LUI of the machine.
To display the automatic shutdown menu on the LUI of the machine, it is necessary to
execute this process.
8. Setting of automatic shutdown menu display
Set 1 for automatic shutdown menu display in service mode (default: 0).
COPIER > OPTION > BODY > SDTM-DSP
9. Turn OFF and then ON the main power.
10. Checking the setting of Auto Sleep Time
In setting menu, check that the setting value of Auto Sleep Time is 1. (If the setting value is 0,
automatic shutdown does not work.)
Menu > Timer Settings > Auto Shutdown Time
4
Disassembly/Assembly > Controller System > Removing the DC Controller PCB > Procedure

Removing the DC Controller PCB

CAUTION:
Be sure to perform "Before Replacing the DC Controller PCB (Refer to page 4-61)"
when replacing the DC Controller PCB, respectively.
■ Before replacing the DC Controller PCB
1) In service mode, perform the following procedure to store the DC Controller setting values.
COPIER > FUNCTION > VIFFNC > STOR-DCN
■ Preparation
1) Remove the Right Cover. Refer to page 4-147.
■ Procedure
1) Remove the DC Controller PCB [1].
• 4 Flat Cables [2]
• 10 Connectors [3]
• Harness Guide [A]
• 4 Screws [4]
[3]
[2]
x14
[3]
[4]
[1]
x3
[3]
[4]
[2]
4-186
[4]
[2]
[4]
[3]
[3]
[A]
4-186
F-4-414

Advertisement

loading

  Also See for Canon MF8580Cdw