Explanation of Symbols
The following symbols are used throughout this Service Manual.
Used to show permission.
Used to show prohibition.
Check the noise.
Disconnect the connector.
Connect the connector.
Remove the cable/wire
from the cable guide or wire
Set the cable/wire to the
cable guide or wire saddle.
Remove the screw.
Tighten the screw.
Remove the claw.
Insert the claw.
Use the bundled part.
Push the part.
Plug the power cable.
Turn on the power.
The following rules apply throughout this Service Manual:
Each chapter contains sections explaining the purpose of specific functions and the
relationship between electrical and mechanical systems with reference to the timing of
In the diagrams,
represents the path of mechanical drive; where a signal name
accompanies the symbol, the arrow
The expression "turn on the power" means flipping on the power switch, closing the
front door, and closing the delivery unit door, which results in supplying the machine with
In the digital circuits, '1' is used to indicate that the voltage level of a given signal is
"High", while '0' is used to indicate "Low". (The voltage value, however, differs from
circuit to circuit.) In addition, the asterisk (*) as in "DRMD*" indicates that the DRMD
signal goes on when '0'.
In practically all cases, the internal mechanisms of a microprocessor cannot be checked
in the field. Therefore, the operations of the microprocessors used in the machines
are not discussed: they are explained in terms of from sensors to the input of the DC
controller PCB and from the output of the DC controller PCB to the loads.
The descriptions in this Service Manual are subject to change without notice for product
improvement or other purposes, and major changes will be communicated in the form of
Service Information bulletins.
All service persons are expected to have a good understanding of the contents of this Service
Manual and all relevant Service Information bulletins and be able to identify and isolate faults
in the machine.
indicates the direction of the electric