Canon MF8580Cdw Service Manual page 169

4
Disassembly/Assembly > Image Formation System > Removing the Patch Density and Registration Sensor unit > Procedure
4) Lift the 2 parts [A] at the front side of the ITB Unit to release the 2 protrusions [1].
[A]
[1]
5) Put the connector [1] through the hole [A] and remove the Patch Density/Registration Patch
Sensor Unit [2].
[A]
[1]
4 Disassembly/Assembly > Image Formation System > Removing the Patch Density and Registration Sensor unit > Procedure
[1]
F-4-213
[2]
F-4-214
NOTE:
When it is difficult to put the connector [1] of the Patch Density/Registration Sensor Unit
[2] through the hole [A], refer to the following steps to remove the Front Cover Link Arm
(Left) so that the connector [1] can be put through the hole [A] more easily.
● Removing the Front Cover Link Arm (Left)
1) Remove the Front Cover. (Refer to page 4-23)
2) Lift the Patch Density/Registration Sensor Unit [1] to remove the Front Cover Link Arm (Left)
[2].
• 3 Screws [3]
[1]
[2]
x1
[3]
4-99
[1]
F-4-215
4-99