Canon MF8580Cdw Service Manual page 333

Item Name
41971 Execution of curl prevention mode 1
Details To extend the initial rotation time and paper interval, and
lower the control temperature.
Use case When paper which has been printed is curled toward the
printed side depending on the paper type, environment
(especially in a low humidity environment) or print pattern
(especially high printing ratio)
Adj/set/operate method Select the item, and then press OK key.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
35607 Execution of down sequence prevention mode
Details To lower the control temperature of the Fixing Assembly
without exception.
Use case When down sequence occurs
Adj/set/operate method Select the item, and then press OK key.
Caution Be sure to get approval from the user in advance by
explaining that there is a possibility that fixing failure may
occur depending on the paper type by lowering the fixing
control temperature.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
37510 ON/OFF of ITB cleaning at paper size mismatch
Details Normally, when paper other than that of the specified size
is fed, ITB cleaning is executed to remove toner.
When 1 is set, ITB cleaning is not executed even if paper
size is mismatched.
Productivity improves, but toner soiling may occur.
Use case When paper size is mismatched
Adj/set/operate method Enter the value, and then press OK key.
Caution Be sure to get approval from the user by telling that toner
soiling may occur to improve productivity.
Display/adj/set range 0 to 1
0: ON, 1: OFF
Default value 0
6
Trouble Shooting > Special Management Mode > Menu List
Description M82 M85
-
-
○
6 Trouble Shooting > Special Management Mode > Menu List
Item Name
65677
Details
○
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Display/adj/set range
Unit
Default value
68676
Details
○
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Display/adj/set range
Unit
Default value
68677
Details
○
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Display/adj/set range
Unit
Default value
Description
Increase of paper leading edge margin
To increase the margin on the leading edge of paper.
As the value is incremented by 1, the margin is increased
by 0.1 mm.
If the setting is incompatible with 68676 (decrease
of margin), the setting is disabled (the margin will be
standard).
2) Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
Decrease of paper leading edge margin
To decrease the margin on the leading edge of paper.
As the value is incremented by 1, the margin is decreased
by 0.1 mm.
If the setting is incompatible with 65677(increase of
margin), the setting is disabled (the margin will be
standard).
2) Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
Increase of paper right and left margins
To increase the margins on the right and left edges of
paper.
As the value is incremented by 1, the margin is increased
by 0.1 mm.
If the setting is incompatible with 25607 (decrease of
margins), the setting is disabled (the margins will be
standard).
2) Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
6-8
M82 M85
○ ○
○ ○
○ ○
6-8