4
Disassembly/Assembly > Controller System > Removing the High Voltage Power Supply PCB > Procedure
Removing the High Voltage Power Supply PCB
■ Preparation
1) Removing the Right Cover. Refer to page 4-20.
2) Removing the Left Cover. Refer to page 4-17.
3) Removing the Rear Upper Cover. Refer to page 4-24.
4) Removing the ADF Unit + Reader Unit. Refer to page 4-32.
5) Removing the Right Front Cover. Refer to page 4-22.
6) Removing the Upper Cover. Refer to page 4-28.
■ Procedure
1) Remove the Harness Cover Plate [1].
• 2 screws [2]
x2
[1]
4
Disassembly/Assembly > Controller System > Removing the High Voltage Power Supply PCB > Procedure
[2]
[2]
F-4-121
2) Remove the harness guide [1].
• 6 claws [2]
x6
[1]
[2]
[2]
3) Disconnect the flat cable [1].
4-63
[2]
[2]
[2]
F-4-122
[1]
F-4-123
4-63