Fixing System; Location; Removing The Fixing Assembly - Canon MF8580Cdw Service Manual

4
Disassembly/Assembly > Fixing System > Removing the Fixing Assembly > Procedure

Fixing System

Location

[1]
[3]
[4]
No. Parts Name Main Unit
[1] Fixing Assembly Product
Configuration
[2] Fixing Motor Unit Product
Configuration
[3] Fixing Pressure Roller Fixing
Assembly
[4] Fixing Film Unit Fixing
Assembly
4 Disassembly/Assembly > Fixing System > Removing the Fixing Assembly > Procedure
[2]
F-4-224
Remarks Reference Adjustment
during parts
replacement
- (Refer to page 4-104) -
M4 (Refer to page 4-111) -
- (Refer to page 4-110) -
- (Refer to page 4-106) -
T-4-23

Removing the Fixing Assembly

■ Preparation
1) Removing the Right Cover. Refer to page 4-20.
2) Removing the Left Cover. Refer to page 4-17.
3) Removing the Rear Upper Cover. Refer to page 4-24.
4) Removing the Rear Cover. Refer to page 4-24.
5) Removing the Rear Lower Cover. Refer to page 4-25.
6) Removing the Rear Cover Rib Unit. Refer to page 4-27.
7) Removing the Duplex Printing Reverse Drive Unit. Refer to page 4-85.
■ Procedure
CAUTION:
When removing the fixing unit, be sure to turn OFF the power.
Since the fixing assembly is extremely hot just after the printing, do not handle it unless
it cools down completely.
If you touch the high-temperature assembly, it may cause a burn.
1) Remove the claw [2] of the harness guide [1] and disconnect the connector [3].
[3]
[2]
[1]
4-104
F-4-225
4-104