4
Disassembly/Assembly > Controller System > Removing the Main Drive Unit > Procedure
CAUTION:
• Be sure to check that the ITB Link [2] of the Main Drive Unit [1] is set at the correct
position as shown in the figure below.If not, turn the ITB Link [2] in the direction of
the arrow to be set at the correct position.
• Be sure to check that the Cartridge Cover Link [3] of the Main Drive Unit [1] is set at
the correct position as shown in the figure below.If not, pull out the Cartridge Cover
Link [3].
• Be sure to install the shaft [4] of the Main Drive Unit by fitting it in the hole [5] of the
Side Plate.
[2]
[5]
[4]
[2]
[3]
4
Disassembly/Assembly > Controller System > Removing the Main Drive Unit > Procedure
[2]
[1]
[3]
F-4-475
4-208
4-208