Modifying The Duration Of A Program - GIRBAU HS-6013 Operation Instructions Manual

4.4. MODIFYING THE DURATION OF A PROGRAM

Once a program is started, the user can modify the rotation and/or spin time. This intervention will always be
possible if the time icon associated with the rotation or spin function appears.
Advancing the program and accessing in order to execute the functions on the following screen is also possible.
Intervention keys on the multi-function keyboard.
Increase the rotation or spin times.
+
0
Decrease the rotation or spin times.
44
Key for advancing to the following function screen.
4.5. INFO SCREEN
Screen that gives diverse information to the user.
This screen is accessed by pressing the key ---i--- on the multi-function keyboard. After a few seconds,
the screen returns to the previous configuration.
Content of information:
Time remaining in the program. Calculation estimated in washing machines without heating systems and
•
normal water pressure conditions.
• Bath level [mm]. Column of bath detected by pressure transmitter.
• Temperature of the bath. Value in centigrade or Fahrenheit according to the washing machine
configuration.
Temperature programmed in the phase. Value in centigrade or Fahrenheit according to the washing
•
machine configuration.
• Level of unbalance (visible during the spin cycle)
• Level of power absorbed by the motor.
4.6. CREASE-GUARD STOP. RINSE HOLD FUNCTION
This function allows interrupting the program from advancing before the final spin cycle of the program starts.
During the interruption time, the washing machine stops the movement of the drum, except for short rotation
movements at very large intervals, keeping the drain closed and the bath inside.
Possible interventions:
The function is activated by the keys on the multi-function keyboard.
To activate the function, press the key
•
RH-ON.
• Once program interruption is activated, the key
program.
• To deactivate the function before the program is interrupted, press the key RH-ON. The key message will
change to RH-OFF.
4.7. STOP MODES
Description of the distinct stop modes of the washing machine.
End of cycle. Stoppage of the washing machine functions after the wash cycle ends. When the drum rotation
ends, the door lock is unlocked. The washing machine control circuit remains in operation.
STOP key. Interrupts the wash cycle in operation and opens the drain of the washing machine. After the bath
has been drained and the drum rotation has ended, the door lock is unlocked. The washing machine control
circuit remains in operation.
NORMAL STOP switch. Switch installed on the front of the washing machine. Disconnect the washing machine
control circuit. DO NOT DISCONNECT the entire electric circuit of the machine. After a maximum safety
time (at times surpassing 3 minutes), the washing machine lock is unblocked.
Emergency stop. Red button with blockage located in a visible, accessible area of the washing machine. It
interrupts the operation of the washing machine. Once the switch is unblocked, the wash program resumes
by pressing the key START; The key STOP cancels the program and after a maximum safety time (at times
surpassing 3 minutes), the washing machine lock is unlocked.
General stop. General switch located on the rear part of the washing machine. TOTALLY disconnects the
electric supply of the machine. Suitable for maintenance interventions and in situations of prolonged machine
stoppage.
Executing Programs
RH-OFF FOR SOME SECONDS. The key message will change to
CONT will blink. Press this key in order to resume the
14
Cod. 429159
Rev. 01/0306