Tilt Models; Tilt Models Specific Safety Instructions; Tilt System Description - GIRBAU HS-6085 Installation Instructions Manual

4. TILT MODELS

ATTENTION!

Tilt models specific safety instructions

During the assembling and operation verification of the TILT system strictly follow the safety precautions
indicated at the beginning of this manual.
The transport and assembling operations of tilt components must be carried out by the Authorised Technical
Service.
Due to mass weight, be specially careful when carrying out these operations. Remember that weights and
measures of TILT models can be found in the Installation specifications, section 1.4.
The TILT SYSTEM has JUST been designed as a system to facilitate the washer's loading and unloading
operations. USING THE TILTING SYSTEM FOR ANY OTHER PURPOSE AND SPECIALLY FOR
MAINTENANCE OPERATIONS IS STRICTLY PROHIBITED.
To avoid any risk during the operation verification of the TILT SYSTEM follow these instructions:
Keep away of the rear of the washer during the tilt movement. Because of the washer's tilting movement,

there is crushing and shearing hazard between the tilting elements and the building elements.
The TILT SYSTEM has JUST been designed to facilitate the washer's loading and unloading

operations.
DO NOT USE the washer until all the guards are properly located and adjusted

In particular take special care to the tilt hinge guards.

DO NOT MISLEAD NOR CANCEL THE POSITION DETECTORS located on the machine brackets.

DO NOT MISLEAD NOR CANCEL THE PUSH-BUTTON that activate the drum's rotation with the door

open.
The pressure of the pneumatic circuit specific for tilting is controlled by a pressure regulator located

on the electrical panel, with a fixed adjustment, DO NOT MODIFY NOR MANIPULATE THIS
REGULATOR.
Because of the facility of rotating the drum with door open, during loading and unloading operations

NEVER MORE THAN ONE PERSON WILL OPERATE WITH THE MACHINE.
The washer is protected against possible incorrect handling, so machine must be in horizontal

position before selecting a tilting movement or starting a wash program.

TILT system description

Set of components that, using the strength of two pneumatic actuators, permit a double tilt movement for the
whole of the machine, forwards and backwards to easily load and unload the washer.
Four position detectors, one at each washer's supports, ensure the correct operation of the tilt system, and a
balanced position during the wash cycle.
The washer's electrical control permits the drum's rotation and reverse by two hold-to-run push-buttons and the
fabric soaking when loaded to reduce the volume.
The bath used to soaking the linen is not kept inside the washer when the wash cycle starts.
TILT models
44
Cod. 511485
Rev. 10/0918