Checking, Disassembling And Servicing 1-S11; Separating Engine; Draining Coolant, Engine Oil And Transmission Fluid 1-S11 - Kubota B2410 Workshop Manual

82410 • 82710 • 82910 WSM, 12271
1 ENGINE
CHECKING, DISASSEMBLING AND SERVICING
[1] SEPARATING ENGINE
(1) Draining Coolant, Engine Oil and Transmission Fluid
Draining Coolant
A
CAUTION
• Never open the radiator cap while operating or immediately
after stopping. Otherwise, hot water will spout out from the
radiator. Wait for more than ten minutes to cool the
radiator, before opening the cap.
1. Loosen the drain cock (2) from the radiator hose to drain cooling
water.
2. Remove the radiator cap (1) to drain coolant completely.
3.8 L
82410 4.0 U.S.qts.
Coolant capacity
3.3 Imp.qts.
(with recovery rank)
82710
4.5 L
82910
4.7 U.S.qts.
4.0 Imp.qts.
3.0 L
82410 3.2 U.S.qts.
Engine oil capacity
2.6 Imp.qts.
82710
4.1 L
82910
4.3 U.S.qts.
3.6 Imp.qts.
Draining Engine Oil
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. Remove the drain plug (1) to drain oil.
4. Screw in the drain plug (1).
(When refilling)
• Fill the engine oil up to the upper line on the dipstick (3) .
• IMPORTANT
• Never mix two different type of oil.
• Use the proper SAE Engine Oil according to ambient
temperature.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-8)
(1) Radiator Cap
(1) Drain Plug
(2) Oil Inlet Plug
1-811
(2) Drain Cock
(3) Dipstick
12271S10090
12271S10100