Xerox WorkCentre 4150 Service Manual page 158

9. Remove the top cover assembly, Figure 8.
1
Disconnect CN5 and 1 ground
harness.
Figure 8 Top cover removal
10. Remove the duplex guide, Figure 9.
1
Carefully twist the front of the
frame to release the duplex guide.
Figure 9 Duplex guide removal
Repairs and Adjustments
REP 5.1
2
Align the flat on the rear pivot with
the slot in the frame. Remove the
top cover assembly from the rear
pivot, then the front pivot.
2
Remove the duplex guide.
September 2006
4-14
11. Remove the upper feed assembly, Figure 10.
1
Remove 2 screws.
Figure 10 Upper feed assembly removal
12. Remove the feed roll assembly, Figure 11.
4
Remove 1 E-clip, 1 bearing,
then the feed roll assembly.
Figure 11 Feed roll assembly removal
2
Disconnect the spring, then
remove the upper feed assembly.
3
Remove 1 E-clip, then the
bearing.
2
Remove 1 E-clip, then the
pickup clutch.
1
Disconnect the inline con-
nector.
WorkCentre 4150