Xerox WorkCentre 4150 Service Manual page 242

PL 8.10 Tray 1-4 Feed Assembly
Item Part Description
1 130N01459 Tray feed assembly (REP 7.1)
2 130N01274 Paper empty sensor (Q07-110
tray1), (Q07-210 tray 2), (Q07-310
tray 3), (Q07-410 tray 4), Stack
height sensor (Q07-150 tray 1),
(Q07-250 tray 2), (Q07-350 tray 3),
(Q07-450 tray 4). (REP 7.2)
3 – Ground strip (P/O PL 8.10 Item 1)
4 – Actuator (P/O PL 8.10 Item 1)
5 – Feed head (P/O PL 8.10 Item 1)
6 – Feed roll shaft (P/O PL 8.10 Item 1)
7 – Bearing (P/O PL 8.10 Item 1)
8 – E-Clip (P/O PL 8.10 Item 1)
9 005N01094 Clutch
10 007N01520 Feed roll gear
11 005N01087 Feed roll drive dog
12 022N02232 Roll assembly (See Note)
13 007N01556 Intermediate drive gear
14 007N01522 Nudger roll gear
15 – Harness (P/O PL 8.10 Item 1)
16 – Spring (Not Spared)
17 – Tray up limit switch (P/O PL 8.10
Item 1) (REP 7.2)
NOTE: This is a HFSI. To reset the HFSI count, go to GP 16.
Parts Lists
PL 8.10
September 2006
5-20 WorkCentre 4150