Xerox WorkCentre 4150 Service Manual page 56

HFSI
The High Frequency Service Items are shown in Table 2. To change HFSI settings, refer to GP
16 High Frequency Service Items.
Table 2 High frequency service items
Item Component Description
T1 Feeds Roll assembly All sheets fed from tray 1
(pick-up roll, after last HFSI reset.
feed roll,
retard roll)
T2 Feeds Roll assembly All sheets fed from tray 2
(pick-up roll, after last HFSI reset.
feed roll,
retard roll)
T3 Feeds Roll assembly All sheets fed from tray 3
(pick-up roll, after last HFSI reset.
feed roll,
retard roll)
T4 Feeds Roll assembly All sheets fed from tray 4
(pick-up roll, after last HFSI reset.
feed roll,
retard roll)
Bypass Rub- Bypass tray The total bypass tray
ber Pad Life retard pad feeds after the last HFSI
Page reset.
DADF Rub- DADF retard The total DADH feeds in
ber Pad Life pad all modes after the last
Page HFSI reset.
DADF Roller DADF feed roll The total DADH feeds in
Life Page assembly all modes after the last
HFSI reset.
Fuser Unit Fuser assem- The total sides of copies
Life Page bly and prints after the last
HFSI reset.
Heat Roll Life Fuser heat The total sides of copies
Page roller assem- and prints after the last
bly HFSI reset.
Pressure Roll Fuser pres- The total sides of copies
Life Page sure roller and prints after the last
HFSI reset.
Transfer Roll Transfer roll The total sides of copies
Life Page and prints after the last
HFSI reset.
Service Call Procedures
SCP 5
Item
The
recommended Toner Car-
life for new tridge Life
component Parts list Page (see
installation reference NOTE)
Developer
180k feeds PL 7.25 Item 11
Cartridge Life
PL 8.10 Item 12
Page (see
NOTE)
180k feeds PL 7.25 Item 11
NOTE: The Toner Cartridge Life Page and the Developer Cartridge Life Page are only dis-
PL 8.10 Item 12
played if non Xerox modules are installed.
180k feeds PL 7.25 Item 11
PL 8.10 Item 12
180k feeds PL 7.25 Item 11
PL 8.10 Item 12
40k feeds PL 8.20 Item 4
45k feeds PL 5.20 Item 12
180k feeds PL 5.15 Item 5
180k impres- PL 10.25 Item 1
sions
180k impres- PL 10.26 Item 12
sions
180k impres- PL 10.26 Item 23
sions
80k impressions PL 7.35 Item 19
September 2006
1-6
Table 2 High frequency service items
The
recommended
life for new
component
Component Description installation
Toner module The total sides of copies 10k (starter
and prints after the last module)/20k
HFSI reset. impressions
Xerographic The total sides of copies 55k impressions PL 9.10 Item 1
module and prints after the last
HFSI reset.
Parts list
reference
PL 9.10 Item 2
WorkCentre 4150