Xerox WorkCentre 4150 Service Manual page 325

Wiring Diagrams
Purpose
Wiring diagrams are an aid to trace wiring faults. Wiring Diagrams are used to complement the
fault analysis information contained in the relevant RAP.
Introduction
The PWB connections are shown in the following wiring diagrams:
Input power and power distribution, Wiring Diagram 1.
HVPS, Wiring Diagram 2.
Main PWB and ROS, Wiring Diagram 3.
Main PWB and main drive assembly, Wiring Diagram 4.
Main PWB, xerographic module, exit drive assembly and registration guide assembly,
Wiring Diagram 5.
Main PWB and tray feed assembly, Wiring Diagram 6.
Main PWB, tray 2 connector and right cover assembly, Wiring Diagram 7.
Main PWB and foreign interface device, Wiring Diagram 8.
Scanner PWB and CCD module, Wiring Diagram 9.
User interface, Wiring Diagram 10.
DADF, Wiring Diagram 11.
Tray 2, 3 and 4 (1 of 2), Wiring Diagram 12.
Tray 2, 3 and 4 (2 of 2), Wiring Diagram 13.
Finisher (1 of 3), Wiring Diagram 14.
Finisher (2 of 3), Wiring Diagram 15.
Finisher (3 of 3), Wiring Diagram 16.
The wiring diagrams have the following features:
• The connections on the PWBs are in numerical sequence where possible.
• The complete component to PWB wiring is shown. All interconnecting connectors shown,
in part or whole. Connectors shown in part have reference to other wiring diagrams as
necessary.
• Where necessary, components have references to show additional connections to them.
• Relevant parts list references are shown.
WorkCentre 4150
September 2006
7-3
Wiring Data
Wiring Diagrams