Xerox WorkCentre 4150 Service Manual page 177

10. Prepare the rear of the registration roll, Figure 2.
2
Remove the E-clip.
Figure 2 Preparation
11. Prepare the front of the registration roll, Figure 3.
1
Remove the E-clip, then the
bearing.
Figure 3 Preparation
WorkCentre 4150
12. Remove the registration roll cover, Figure 4.
1
Remove the E-clip,
then the bearing.
13. Remove the actuator assemblies, Figure 5.
14. If necessary, remove the duplex jam 2 sensor actuator assembly, PL 8.15 Item 15.
September 2006
4-33
2
Unclip, then remove the
registration roll cover.
Figure 4 Cover removal
1
Unclip, then remove both actuator
assemblies.
Figure 5 Actuator assembly removal
Repairs and Adjustments
1
Remove 2 screws.
REP 8.2