Xerox WorkCentre 4150 Service Manual page 351

ACC 1 Foreign Device Interface PWB Checkout
Procedure
Go to the 03-500 Use Auxiliary Access RAP.
WorkCentre 4150
ACC 2 Foreign Device Interface Installation
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
Installing the Foreign Device Interface
1. Unpack the components of the foreign device interface kit.
2. If necessary, disconnect the finisher harness and the network cable.
3. If necessary, remove the fax module, PL 1.10 Item 14.
NOTE: Leave the fax cable connected to the fax module.
4. Remove the infill cover, PL 1.10 Item 19.
5. Carefully remove the foreign device interface push-out from the infill cover, Figure 1.
6. Remove the rear cover, PL 28.10 Item 6.
September 2006
8-3
WARNING
WARNING
CAUTION
1
Remove the push-out.
Figure 1 Push-out removal
ACC 1, ACC 2
Accessories