Xerox WorkCentre 4150 Service Manual page 238

PL 7.25 Trays 2 - 4 Frame Assembly (2
of 2)
Item Part Description
1 – Retard assembly (P/O PL 7.20 Item
1)
2 – Actuator (P/O PL 7.25 Item 1)
3 – Drive shaft (P/O PL 7.25 Item 1)
4 – Retard bracket (P/O PL 7.25 Item
1)
5 – Retard shaft (P/O PL 7.25 Item 1)
6 006N01293 Pin
7 – E-Clip (P/O PL 7.25 Item 23)
8 – Bearing (P/O PL 7.25 Item 23)
9 022N02231 Drive dog Coupling
10 017N00259 Drive dog
11 022N02232 Roll assembly (See Note 2)
12 – Spring (P/O PL 7.20 Item 1)
13 – Retard roll release assembly (P/O
PL 7.20 Item 1)
14 130N01274 Tray feed sensor, SCF door sensor
(See Note 1) (REP 7.2)
15 – Cradle (P/O PL 7.25 Item 23)
16 – Actuator (P/O PL 7.25 Item 23)
17 – Spring (P/O PL 7.25 Item 23)
18 – Paper transport housing (P/O PL
7.25 Item 23)
19 009N01605 Spring Clutch
20 – Bush holder (P/O PL 7.25)
21 007N01529 Gear (REP 7.2)
22 – Transport roll (P/O PL 7.25 Item 23)
23 – Paper transport (Not Spared)
24 – Gear, retard assembly (P/O PL 7.20
Item 1)
25 – Gear, paper transport assembly (P/
O PL 7.20 Item 1)
26 – Tray feed assembly (REF: PL 8.10)
27 – Paper guide assembly (P/O PL
7.20 Item 1)
28 – E-Clip (P/O PL 7.20 Item 1)
29 – Gear, tray feeder assembly (P/O PL
7.20 Item 1)
30 005N01085 Tray pickup clutch (Tray 2 CL08-
820), (Tray 3 CL08-830), (Tray 4
CL08-840)
31 – Rear frame (P/O PL 7.20 Item 1)
32 – R/H base (P/O PL 7.20 Item 1)
NOTE: 1. The tray feed sensor and the SCF door sensor
component control codes are common, (Tray 2 Q08-200),
(Tray 3 Q08-300), (Tray 4 Q08-400).
NOTE: 2. This is a HFSI. To reset the HFSI count, go to GP
16.
Parts Lists
PL 7.25
September 2006
5-16 WorkCentre 4150