REP 12.1 Finisher Removal
Parts List on PL 12.10, PL 12.15, PL 12.20, PL 12.25, PL 12.30, PL
12.35, PL 12.40 and PL 12.45
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1.
Open the finisher front door, PL 12.10 Item 1.
2.
Disconnect the finisher interface harness, PL 12.10 Item 18 from the machine.
3.
Remove the finisher stacker tray, PL 12.45 Item 1.
4.
Remove the finisher, Figure 1.
1
Release the latch.
2
Pull out the finisher until it latches in the
second stop.
3
Again, release the latch.
4
Remove the finisher
Figure 1 Finisher removal
WorkCentre 4150
Replacement
Replacement is the reverse of the removal procedure.
September 2006
4-51
Repairs and Adjustments
REP 12.1