Xerox WorkCentre 4150 Service Manual page 217

ADJ 5.1 DADF Side Edge Registration Adjustment
Purpose
To correctly set the DADF side edge registration.
Procedure
Perform the following:
1. Raise the input tray assembly, PL 5.10 Item 5.
2. Remove the lower cover, PL 5.10 Item 11.
3. Loosen the screw that secures the pinion gear, PL 5.10 Item 9 until the pinion gear is
clear of the document guides.
4. Carefully move both document guides to the front or the rear to adjust the registration.
NOTE: Moving both document guides 1 tooth on the pinion gear will adjust the registra-
tion by approximately 3mm (0.1 inch).
5. Assemble the input tray assembly.
6. Use the DADF to make 10 copies of a document. Check the registration, refer to IQS 3
Registration. If necessary, re-adjust the registration.
WorkCentre 4150
September 2006
4-73
Repairs and Adjustments
ADJ 5.1