Accessing The Configure Menu Using The Operator Control Panel; Entering Network Settings Using The Operator Control Panel - IBM System Storage TS3100 Installation Quick Reference Manual

To configure your library, you will be using the Operator Control Panel and/or the Web User Interface.
Static library network settings must be entered using the Operator Control Panel before the library can be
accessed remotely using the Web User Interface. If your system is serviced by DHCP (Dynamic Host
Configuration Protocol) server, the network parameters will be automatically set. Once remote access has
been established, you can complete the configuration of your library.
Choosing your Configuration Method
If you choose to use the Operator Control Panel for configuring your library, go to "Configure Your Library
using the Operator Control Panel" on page 1-21.
If you choose to use the Web User Interface for configuring your library, enter your library network settings
using the Operator Control Panel (see "Accessing the Configure Menu using the Operator Control Panel"
and "Entering Network Settings using the Operator Control Panel"), then go to "Configure Your Library
using the Web User Interface" on page 1-14,.

Accessing the Configure Menu using the Operator Control Panel

1. Press the UP button to display the Main menu.
2. Press the DOWN button to select Configure.
3. Press the ENTER button to display the Configure menu.

Entering Network Settings using the Operator Control Panel

If you would like to use DHCP (Dynamic Host Configuration Protocol ) as your library network setting,
complete Steps 1, 2, 3, and 7. If you do not want to use DHCP as your library network setting, complete
Steps 1, 2, 4, 5, 6, and 7.
1. Press the DOWN button to highlight the Network menu.
2. Press the ENTER button to display the Network screen.
3. If you do not want to select DHCP as your library network setting, skip this step and proceed to the
next step. If you want to select DHCP as your library network setting, complete the following steps:
a. Press the ENTER button to highlight the DHCP field.
b. Press the DOWN button to select ON.
c. Press the ENTER button to apply your selection.
d. Skip to Step 7.
4. Press the DOWN button to select IP Address.
a. Press the ENTER button to highlight the IP Address field.
b. Press the UP or DOWN button to select the digit(s) of your library's IP Address.
c. Press the ENTER button to highlight the next digit(s) in your IP Address.
d. After entering the final digits, press the ENTER button to apply your entries.
5. Press the DOWN button to select Netmask.
a. Press the ENTER button to highlight the Netmask field.
b. Press the UP or DOWN button to select the digit(s) in your library's Netmask address.
c. Press the ENTER button to highlight the next digit(s) in your library's Netmask address.
d. After entering the final digit(s) in your Netmask address, press the ENTER button to apply your
entries.
6. Press the DOWN button to select Gateway.
a. Press the ENTER button to highlight the Gateway field.
b. Press the UP or DOWN button to select the digit(s) in your library's Gateway address.
1-13
Installation