Configuring The Ipmi Port From The Netbackup Appliance Shell Menu - VERITAS NetBackup 5330 Installation Manual

Configuring the IPMI port from the NetBackup
Appliance Shell Menu

Configuring the IPMI port from the NetBackup Appliance Shell Menu

A blinking, amber LED indicates that a RAID rebuild is in progress.
■
The Activity LED (2) indicates the following:
The LED is not lit when the disk has spun down, although power is still
■
on.
The LED is solid green when there is no disk activity, although power
■
is still on.
The LED blinks green when the disk spins up.
■
The LED blinks green occasionally when commands are processed.
■
13
Launch the NetBackup Appliance Web Console and verify that all devices
appear on the Monitor > Hardware page. If the devices do not appear, inspect
the cable connections and make sure that the power is on.
14
Proceed to the initial configuration of the appliance. Refer to instructions at the
following site.NetBackup Appliance documentation
This section explains how to configure IPMI from the NetBackup Appliance Shell
Menu.
Before starting the IPMI configuration, obtain the following information for the
appliance for which you want to configure the IPMI:
IP address IP address for the remote management port so that the default static IP
address of the remote management port can be changed.
Subnet mask Enable connectivity between your network computer and the remote
management port.
Gateway IP Enable connectivity between your network computer and the remote
address management port.
The defaults for the remote management port are:
IP Address: 192.168.0.10
■
Subnet Mask: 255.255.255.0
■
Also review the following section on the IPMI prerequisites.
See "Prerequisites for IPMI configuration"
Hardware installation procedures
on page 33.
81